□ Connect the Throttle Controller’s connector to the foot pedal
assembly.
□ Connect the Throttle Controller’s remaining connector to the
OEM harness for the foot pedal assembly.
□ Locate the blunt-cut OEM SEIC wire harness, on the driver’s
side just below the OBDII port (Figure 5.5). You will need to find
the following wires:
• ignition-switched 12V OEM SEIC circuit CDC64 –
▪ yellow wire with orange stripe on early builds
▪ white wire with blue stripe on later builds
• tachometer signal OEM SEIC circuit CE913 – blue wire
• transmission park signal OEM SEIC circuit CLS05 – blue
with grey stripe (marked previously)
• park brake switch OEM SEIC CMC25 – white wire with
purple stripe
Figure 5.5
□ Solder and seal the long red ‘KEY SWITCHED 12V’ wire
(coming from the shrink-wrapped diode) to the OEM SEIC circuit
CDC64 yellow with orange stripe wire on early builds, white with
blue stripe wire on later builds, at the blunt-cut harness.
To Next Page
Loading...
