Need help?Do you have a question about the VOGELS VGI and is the answer not in the manual?
Overview of the VGI gas system, its sequential slave injection principle, and basic operation.
Details the various input and output signals used by the VGI system for engine monitoring and control.
Identifies and illustrates the key physical components of the VGI gas system.
Outlines pre-installation checks, vehicle compatibility, and general installation remarks.
Provides a schematic view and instructions for the correct connection of gas hoses.
Describes available pressure regulators (L102, IG1, Palladio) and installation instructions.
Explains the function, technical specifications, and installation procedure for the gas filter unit.
Details injector rail types (Landi GI, AEBINJ, Valtek), specs, and installation instructions.
Describes engine nozzles, their specifications, and detailed installation instructions.
Explains the role, technical specifications, and installation of the water temperature sensor.
Provides specifications and installation instructions for the AEB025 MAP sensor.
Outlines Gas ECU functions, hardware versions, and electrical connection details for various types.
Gives crucial guidelines for safely and correctly installing the Gas ECU unit.
Covers general electrical setup, fuse installation, signal cutting, and OBD connections.
Explains user interface functions, LPG level indication, and emergency start procedure.
Discusses the minimal maintenance requirements for the VGI system and its dependency on installation quality.
Details procedures for checking error codes, performing external system checks, and filter unit maintenance.
Guides on how to verify and adjust the system's operating pressure.
Offers advice on engine tuning, recommended maintenance intervals, and leak detection.
Provides essential safety precautions and actions to take following an accident.
To Next Page
General