Vogels Autogas Systems VGI Hardware Manual System Description and Installation
VGI Technical Manual 2014-01-14.pdf Pagina 35 van 44
1.14 Electrical Installation Instructions:
The majority of electrical connections are realised via the preassembled wire harness with connectors.
The following applies to electrical connections:
• Follow the diagrams for the relevant installation instructions.
• Keep the wire harness as far away as possible from heat sources such as the exhaust, radiator, etc.
• Keep the wire harness away from moving components such as the cooling fan and shift mechanism.
• Keep the wire harness as far away as possible from high-voltage components such as the ignition system.
• Where possible, follow the route of the original wiring and attach the Eurogas Omegas wire harness carefully
using binding strips. All of this is essential for providing access to components during maintenance work.
• Wire to wire connections should be soldered and well isolated, to prefend corrosion in a later stage.
• Wire to contacts and terminal connections be soldered and well isolated, to prefend corrosion in a later stage.
• Use a shrink sleeve on connections that have been soldered.
• Connect the 12-V power supply to the positive terminal of the battery.
• Connect the potential mass to the negative terminal of the battery.
• Connect the reference earth to the reference earth of a vehicle such as the negative terminal of the battery or
chassis.
1.14.1 Fuse Installation Instructions
Fuse is used to protect the system from oversized current. It has to be fitted near the
car battery in order to be detected easily. Preferably fixe the fuse at the top of the battery. The maximum
acceptable current is 15A.
To Next Page
Loading...