Vogelsang VX136Q - 3 Specifications

Specifications
WBV.PU.002.EN VX136Q V2.0
11
3 Specifications
VX136Q
series
Max. rotation speed: 800 min
-1
Max. differential
pressure**
Theoretical
torque***
Displacement
Theoretical volume
flow*
Size
[l]
[l/min]
[m
3
/h]
[bar]
[Nm]
70
1.29
1032
62
10
240
105
1.93
1544
93
10
355
140
2.58
2064
124
8
390
210
3.87
3096
186
5
395
* All values refer to the theoretical volume flow. The actual volume flow is lower; it depends on the
operating conditions in each case.
** Valid only for short operation times. For continuous operation, please contact our service department
.
The service life of the lobes is reduced by high temperatures, especially in combination with high
pressure. Observe the material-specific differential pressure limits  Notice.
*** Theoretical operating torque with max. differential pressure and water, designed for NBR elastomers.
ATTENTION
Speed reduction for highly viscous media
When using the pump for a highly viscous medium, the pump speed must be reduced according to the
material's viscosity, to prevent the intake flow from breaking off on the suction side (cavitation protection).
Material-specific differential pressure limits
With some materials, premature wear is likely if the pump pressure is too high. Observe the following
material-specific differential pressure limits.
FPM lobes: max. 6 bar
Steel or stainless steel lobes: Please consult our service department 
Cartridge mechanical seal made of Duronit: max. 10 bar
Maximum free passage: Ø 40 mm
Weights and dimensions
For the machine's weight and dimension specifications, see "Dimension sheet"