WBV.PU.002.EN VX136Q V2.0
6.5 Base, support surface for machine
6.5.1 Machine without base
Risk of crushing or concussion due to falling machine caused by insufficient stability!
• The machine must be securely fastened to the supporting surface. The machine must never be held in
position by the connected pipe as this could result in the couplings breaking or failing.
• Retighten all machine fastening screws and nuts after 20 operating hours and then every 2000
operating hours (at least once a year).
6.5.2 Machine and motor on base C (with coupling)
Impairment of communication and discomfort due to machine vibration!
A tensioned base or insufficient fastening of the machine and motor to the base can lead to machine
vibrations and discomfort.
• Install the base in a stressless manner on the support surface.
• Retighten all screws and nuts for fastening the motor and the machine to the base after 20 operating
hours and then every 2000 operating hours (at least once a year).
After fastening the machine to the base and the base to the ground on which the machine is standing, the
coupling orientation must be checked and realigned, if necessary.
In addition, also read and observe the following: "Coupling manufacturer's operating instructions"
Injuries caused by friction, catching, abrasion from the exposed rotating drive shaft or coupling!
If the machine starts up unexpectedly during adjustment or repair work on the coupling or the dismounted
coupling guard, this can result in accidental contact with the exposed rotating drive shaft or coupling.
Before performing adjustments or repair work on the coupling, switch the machine off and secure it against
being switched on again.
To Next Page
Loading...
