Drive unit
•
Check the level of the gear lubricant and top up as
necessary.
Open the oil filler cap (1) so that excess
pressure is released. Undo the oil dipstick (3) with
the aid of a standard 1/2" extension (2).
•
Replace the dipstick but do not screw it down before
reading off.
IMPORTANT!
The Volvo Penta IPS unit must be stopped for at least
12 hours before a correct oil level check can be made.
Instrument and control system (EVC system)
•
Carry out auto configuration (refer to the EVC sys-
tem installation manual)
•
Verify that complete calibration has been made
(refer to the EVC system installation manual)
•
Start the EVC display(s) and check functionality
•
Check any fault codes
IPS 2/3 drive unit
4, Connect breather hose
5, Water in oil sensor
To Next Page
Loading...
