Volvo Sensus - Bluetooth Handsfree Phone - Audio Settings; Making and Receiving Calls

03 Audio and media
03
}}
59
Making and receiving calls
Functions for handling phone calls.
Incoming call
– Press OK/MENU to answer the call, even
if the audio system is in e.g. RADIO or
MEDIA mode.
Refuse or end with EXIT.
In call menu
In the normal view for the phone source, one
press on OK/MENU during the current call
gives access to the following functions:
•
Mobile phone - the call is transferred
from handsfree to the mobile phone. For
some mobile phones the connection is
interrupted. This is normal. The handsfree
function asks if you want to reconnect.
•
Mute microphone - audio system micro-
phone is muted.
•
Dial number - option to call a third party
using the number keys (current call set in
standby).
Call register
The call register is mirrored in the handsfree
function at each new connection and is then
updated during the connection. In the normal
view for the phone source, turn TUNE to the
left to see the call register.
In the normal view for the phone source, you
can see the call register for the connected
phone by pressing OK/MENU and then
selecting
Call list.
NOTE
To show the connected mobile phone's
call register in the car, mirroring must be
accepted in the mobile phone when it is
connected. Depending on the mobile
phone, this can be activated by means of
the following:
•
a pop-up box or a notification is
shown and accepted in the phone.
•
accept sharing of information in the
phone's settings for the Bluetooth
®
connection to the car.
In some cases it may be a requirement
that the mobile phone is disconnected and
reconnected to the car in order for mirror-
ing to be activated.
Related information
•
Audio and media - operating the system
(p. 28)
•
Voice recognition - mobile phone (p. 66)
•
Bluetooth
®
handsfree phone (p. 57)
•
Bluetooth
®
handsfree phone - audio set-
tings (p. 59)
•
Phone book (p. 60)
Bluetooth
®
handsfree phone - audio
settings
It is possible to adjust the call volume, audio
system volume and ring signal volume.
Phone call volume
The phone call volume can only be changed
during a call. Use the steering wheel keypad
or turn the VOL control.
Audio system volume
Providing there is no ongoing call taking
place, the audio system volume is controlled
as usual by turning VOL.
If an audio source is active on receipt of an
incoming call then it is muted automatically.
Ring signal volume
The ring signal volume can be changed by
pressing the SOUND button, turning TUNE to
Ringtone volume and pressing OK/MENU.
Adjust the ring signal volume by turning
TUNE and save the setting with OK/MENU.
Ring signals
The handsfree-function's built-in ring signal is
used for incoming calls.
NOTE
For certain mobile phones the connected
mobile phone's ring signal is not switched
off, and is then used at the same time as
the handsfree system's built-in signal.