PROPixx installation
You will need a flat, stable area to install your PROPixx. Also, familiarize yourself with the following simple guidelines
concerning the installation of your PROPixx system.
• The projector should be installed as close to the power outlet as possible.
• The power connection should be easily accessible, so that it can be disconnected in an emergency.
• Ensure that there is at least 30 cm (12 in) of space between the ventilation outlets and any wall, and 10 cm (4 in) of
space for all other sides.
• Do not install the projector close to anything that might be affected by its operational heat (polystyrene ceiling tiles,
curtains, etc.)
• When stacking projectors, the stack MUST be vertical, to ensure that the stresses are distributed to all four chassis
corners.
• Do not place heavy objects on top of the projector chassis. Only the chassis corners are capable of withstanding the
weight of another projector.
• Do not drop or knock the projector.
• Place the projector in a dry area away from sources of dust, moisture, steam, smoke, sunlight or heat.
The projector weighs approximately 15 kg (33 lbs). Use safe handling techniques when
lifting the projector. Backup safety chains or wires should always be used with ceiling
mount installations.
Never cover the lens while the projector is switched on. This could pose a fire hazard.
Copyright © 2015 VPixx Technologies Inc. All Rights Reserved
To Next Page
