VPixx Technologies PROPixx Full - Powering the Device; Device Detection; Status LED; Table 1 Status Leds

22
Powering the device
Once all cables have been properly connected, you can power on your PROPixx. The power up procedure is as follows:
1. Toggle the controller’s power switch to the ON position.
2. On the projector, press the button once to switch the projector ON.
Pressing the projector’s button continually for 3 seconds or more will put it in SLEEP mode.
Device detection
After toggling the power switch to ON, your computer should detect the projector and controller and perform the
necessary installation. On a Mac OS X system, no driver is required; however under Microsoft Windows, a driver must
be installed.
Status LED
Your PROPixx is equipped with two status LEDs that supply information on the energy or power status of your system.
The information relayed by each LED, one blue and one red, is summarized in the table below.
Table 1 Status LEDs
ON
Blinking
BLUE LED Awake Mode LED Off mode
RED LED
Sleep Mode
Thermal Shutdown
Copyright © 2015 VPixx Technologies Inc. All Rights Reserved