3 Software Installation
3.1 Downloading the SDK
Downloading the software package:
1. Visit www.vrmagic.com/imaging/downloads/ .
f The software for USB cameras can be found beneath the heading “Software
for USB Components”.
2. Dependent upon on the operating system of the target system (Linux or Win-
dows, 32 bit or 64 bit), download the .zip file VRmUsbCam DevKit for Windows
... or the .tar.bz2 file VRmUsbCam DevKit for Linux ... .
3. Unpack the downloaded file.
3.2 Installing the SDK
Note
You may install both the 32 bit version (X86) and the 64 bit version (X64) of the
SDK in parallel, if required.
Installing the software development kit (Windows):
1. Navigate into the directory created after unpacking the downloaded file.
2. To install the SDK, run setup.exe.
3. Follow the on-screen instructions.
f After successful installation a message is displayed. A new folder VRmagic
was created in your Windows start menu. Several folders were created on your
hard drive ( 3.3.1 on page 15).
Installing the software development kit (Linux):
1. Navigate into the directory created after unpacking the downloaded file.
2. To install the SDK, execute
./VRmUsbCamDevKitForLinuxX**-install as
root (**= 64 or 86). For further information, refer to the README file in the same
directory. Several folders were created on your hard drive ( 3.3.2 on page 16).
USB Cameras – User Guide14
To Next Page
Loading...