44
Please note: If the LED for the reminder function is activated then the
handswitch is no longer in standby mode as long as the light is switched
on/active.
4.9 Container and shelf stop
Up-Down with memory and Up-Down with memory and display
These two functions can be used to limit the desk’s travel range (for
example, if there is a container under the desk). A container stop po-
sition can be set in the bottom half of the travel range and a shelf
stop position in the top half. If a container stop position is set then
this acts as the new lower end position. A shelf stop position acts as
a new upper end position for the travel range. Proceed as follows to
save a container/shelf stop position:
- Move the desk to a position of your choice by pressing the up or
down control.
- To set a container stop position, hold down the Bluetooth® button
for 8 seconds and simultaneously press the handswitch downwards.
- To set a shelf stop position, hold down the Bluetooth® button for 8
seconds and simultaneously press the handswitch upwards.
- The LED lights up in white twice to confirm.
- To clear the stop positions, hold the star and bell buttons down for 8
seconds.
5. Troubleshooting
5.1 The desk does not move
- Check whether the maximum operating time has been exceeded (see
section 7) and the operating time restriction has been activated.
- Check whether all the cables are inserted correctly (and if necessary
whether there is a functioning electricity supply).
- Make sure that the load (see section 7) on the desk is not too high.
- Make sure that no obstacles are blocking the travel path.
To Next Page
Loading...
