Troubleshooting (continued)
The audio monitor produces high-pitched noise.
The parent unit may be too close to the baby unit or another parent unit.
Make sure the parent units and the baby unit are at least 1 metre away
from one another.
You may be too close to the baby unit or another parent unit when you
press and hold TALK. Make sure the parent units and the baby unit are
at least 1 metre away from one another.
You may have set the sensitivity level too high. You may need to adjustYou may need to adjust
the sensitivity level to a lower level to avoid audio feedback (page
13).
My parent unit plays any sounds from the baby unit and I
think it is too noisy.
You may have set the sensitivity level to the highest level (LEVEL 5).
If you do so, the baby unit will transmit any sounds detected to the
parent units. You may need to adjust the sensitivity level to a lower
level (page 13).
You may need to adjust the speaker volume on the parent unit (page
19).
My parent unit does not play any sound when there is
noise from the baby unit.
Make sure the parent unit is powered up by connecting it to AC power
(page 5) or to the rechargeable battery pack provided ( (page 3).
Make sure the power adapter and the parent unit are plugged in
correctly and securely (page(page 5)..
Make sure the parent unit is turned on (page 19) and the speaker
volume is not set to VOLUME OFF (page 19).
The parent unit may be too far away from the baby unit. Move the
parent unit closer to the baby unit (but not less than 1 metre).
If the parent unit is powered by the provided battery pack, make sure
there is sufficient charge. Charge the battery in the parent unit for up to
11 hours.
You may have set the sensitivity level to a very low level. If you do so,
the baby unit will not detect sounds that is too soft or light. You may
need to adjust the sensitivity level to a higher level (page 13).
•
•
•
•
•
•
•
•
•
•
•
To Next Page
Loading...
