25
Appendix
Troubleshooting (continued)
Other electronic products such as HAM radios and DECT cordless
phones can cause interference with your audio monitor. Try installing
your audio monitor as far away as possible from these types of
electronic devices.
Large obstructions may impact the reception. Try to relocate the baby
unit, away from large obstructions such as walls and doors.
Completely remove and install the battery again. Turn on the baby unit
and the parent unit. Allow up to one minute for the parent unit and the
baby unit to synchronize.
The light and LOW BATTERY ash on the parent unit.
Charge the battery in the parent unit for up to 11 hours.
Completely remove and install the battery again and use it until fully
depleted, then recharge the battery in the parent unit for up to 11 hours.
If the above measures do not correct the problem, replace the battery.
The battery does not charge in the parent unit or the
parent unit battery does not accept charge.
Make sure the battery is installed in the parent unit battery compartment
correctly. The light on the parent unit should be on.
Completely remove and install the battery again, then charge for up to
11 hours.
If light on the parent unit is not on, refer to The light on the
parent unit is off below.
If the battery is completely depleted, it may take up to 30 minutes to
charge the parent unit before it can be used for a very short time
(page 6).
Purchase a new battery. Refer to Parent unit battery installation
(page 3) and Parent unit battery charging (page 6).
The light on the parent unit is off.
Make sure the parent unit battery is installed (page 3) and charged
(page 6) correctly.
Make sure the power adapter and the parent unit are plugged in correctly
and securely.
Unplug the parent unit power adapter. Wait for 15 seconds before
plugging it back in. Allow up to one minute for the baby unit and parent
unit to reset.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
To Next Page
Loading...
