Getting started
8
Rotate the mounting bracket 180 degrees.3.
Plug one end of the telephone line cord into the TEL LINE jack on the back
of the telephone base. Bundle the telephone line cord and secure it with a
twist tie. Place the bundled telephone line cord inside the mounting bracket.
Route the telephone line cord through the slots of the mounting bracket.
4.
Insert the center tabs of the mounting bracket in slots and . Snap the
outer tabs of the mounting bracket in slots and .
5.
Use slots , , and for
the tabletop-mount position.
Use slots , , and for
the wall-mount position.
Center tabs
To Next Page
Loading...
