Handset battery
Once you have installed the battery, the battery indicators show the battery status
(see the table followed).
For best performance, keep the handset in the telephone base or charger when not in use.
The battery is fully charged after 12 hours of continuous charging.
Battery indicators Battery status Action
The screen is blank, or
shows Place in charger
and flashes.
The battery has no charge
or very little charge. The
handset cannot be used.
Charge without interruption
(at least 30 minutes).
The screen shows Low
battery and flashes.
The battery has enough
charge to be used for a
short time.
Charge without interruption
(at least 30 minutes).
The screen shows
HANDSET X.
The battery is charged. To keep the battery
charged, place it in the
telephone base or charger
when not in use.
Mount the telephone base
The telephone comes ready for tabletop use. If you have already installed the
telephone for tabletop use, unplug the telephone line cord from the telephone wall
jack, and unplug the telephone base power adaptor from the wall outlet before
mounting your telephone on a wall. Follow the steps below to mount your telephone
on a wall.
Press down on the tabs on the wall mount bracket on the telephone base to
release it from tabletop orientation.
•
•
1.
To Next Page
Loading...
Need help?
General
