To Next Page

To Previous Page

Set Alert Schedule as Always on

The default setting of sensors’ alert schedule is Always on.

You will receive an announcement alert - “Contact X is open”

or “Motion X sensor detected motion”, every time a monitored

door, window, drawer, cupboard or jewelry box is opened, or

there is motion in the monitored area.

You can also set a reminder in case you forget to close the

monitored object. You can choose to receive an alert once

again if it remains open after 15, 30, or 60 minutes.

Press SENSORS on the handset or telephone base when

idle, and then press or on the handset, or CALLS / or PHONEBOOK/

on the telephone base to scroll to the desired sensor.

-OR-

i. Press MENU when the phone is not in use.

ii. Press or on the handset, or CALLS / or PHONEBOOK/ on the

telephone base to scroll to Sensors, and then press SELECT.

iii. Press or on the handset, or CALLS / or PHONEBOOK/ on the

telephone base to scroll to the desired sensor, and then press SELECT.

2. Press OPTIONS to enter the individual sensor menu.

3. Scroll to choose Set schedulechedule, and then press SELECT.

4. Press SELECT to select Always on. The reminder menu appears.

5. Scroll to choose Off, 15 minutes, 30 minutes, or 60 minutes, and then press

SELECT to save.

NOTES

When you received the alert tone and announcement, the handset will display Contact X

is open or Motion X detected motion, whilst the telephone base will display Contact X

is open or Motion X sensor detected motion.

For Contact Sensor, both the handset and telephone base will also display , and the

SENSOR indicator on the telephone base will turn red.

•

Set schedule

Open/closed 1

VTech VC7002A User Manual

Questions and Answers: