VTech VC7002A User Manual

76
The sensor does not
work at all.
Make sure batteries are installed.
Check if the SENSORS softkey is displayed on the idle screen of the
telephone base or handset. If yes, press SENSORS and then scroll to
check if the desired sensor is on the sensor list. If the desired sensor is
not found, then it may be deregistered from the telephone base.
Press MENU on the telephone base when idle.
Scroll to Sensor setup, and then press SELECT.
Scroll to Add new sensor, and then press SELECT. The screen
displays For sensor pairing process, see manual.
Press NEXT after you initiated the pairing process at your sensor.
Refer to the online User’s manual of VC7151/VC7152, or the User’s
manual that comes with your new sensor, to register the sensor to
the telephone base.
1.
2.
3.
4.
The sensor may be out of range. Move the sensor closer to the
telephone base.
I cannot receive alerts
when the monitored
door, window, drawer,
cupboard or jewelry box
is opened.
Make sure the sensor alert system is in armed mode and that
L
or
R
appears on the display.
If the icon does not appear on the display, press ARM to turn on the
sensor alert system.
For various alerts behavior, please check the settings of alert
notifications (page 38) and individual sensors’ alert schedule (page 34
to 37).
I want to replace an old
sensor with a new one.
To replace a sensor, you must deregister the registered sensor first,
and then register the new sensor to your telephone base.
Press MENU when the phone is not in use.
Enter the code *33734# to access the DEREGISTER menu.
Scroll to Single sensor, and then press SELECT.
Scroll to the sensor you want to deregister, and then press
SELECT.
Press YES to confirm the deregistration.
The telephone base shows Contact X is deregistered and you hear
a beep when the deregistration process completes.
1.
2.
3.
4.
5.
The answering system
does not announce the
correct day of the week
for recorded messages
time stamp.
Make sure you have set the date and time. See Configure your
telephone section.
The answering system
does not answer after
correct number of rings
or does not record
messages.
Make sure the answering system is on. When the answering system is
on, the telephone base and handset show and the /ANS ON
indicator on the telephone base is on.
If toll saver is selected, the number of rings
changes to two when there are new messages.

VTech VC7002A Specifications

General

Brand	VTech
Model	VC7002A
Category	Accessories
Language	English