VTI Instruments EX1629 - Page 103

www.vtiinstruments.com
EX1629 Command Set 103
Command
Description
vtex1629_set_shunt_enabled
Enables or disables the shunt resistors for a
particular list of channels.
vtex1629_set_shunt_source
Sets the shunt source for a given list of
channels.
vtex1629_set_shunt_value
Sets the value of a shunt resistor based on a
given channel and shunt source.
vtex1629_set_strain_units
Determines whether the EX1629 will return
strain measurements in units of strain (ε) or
microstrain (µε) for a given list of channels.
vtex1629_set_synch_source
Sets the sample clock source.
vtex1629_set_tare
Sets the tare values for a list of channels.
vtex1629_set_teds_data
Writes data to a TEDS device on a particular
channel.
vtex1629_set_trigger_count
Sets the trigger count for the EX1629.
vtex1629_set_trigger_delay
Sets the trigger delay for the EX1629.
vtex1629_set_trigger_source
Sets the trigger source on the EX1629.
vtex1629_set_trigger_source_timer
A convenience functions that makes calls to
several other driver functions.
vtex1629_set_trigger_timer
Sets the trigger timer for the EX1629.
vtex1629_set_unstrained_voltage
Sets the unstrained voltage for a list of channels
vtex1629_soft_arm
Sends a software generated ARM event to the
EX1629.
vtex1629_soft_synch
Sends a software generated synchronization
event to the device.
vtex1629_soft_trig
Sends a software-generated TRIG event to the
EX1629.
vtex1629_store_current_config
Stores the current configuration of the
instrument in the nonvolatile storage.
vtex1629_trig_init
Initiates the trigger system.
vtex1629_unlock
Unlocks the EX1629 instrument.
vtex1629_write_teds_MLAN
Writes a variable sized block to a TEDS
EEPROM.
vtex1629_zero_cal
Resets the offset values of the unit before a
measurement is taken.