6 vwr.com I Instruction manual VWR
®
PCR Cycler XT
96
DELIVERY CONTENTS
After receipt of the system, please check if the following items are included in the shipment. If any
transport damage is noticed, contact your distributor or manufacturer immediately.
IMPORTANT NOTICE: IF YOU FIND ANY DAMAGE OF THE DEVICE, DO NOT USE THE DEVICE!
1 Thermal cycler
1 Power cord
1 Instruction manual
1 Link PC-software VWR 'PCR Cycler XT Software'
UNPACKING
Remove the instrument from its packaging and inspect it for signs of damage. If any are
discovered, inform your supplier immediately
The instrument must be placed on a stable, level surface and positioned such that air can
circulate freely around the casing
Ensure your proposed installation site conforms to the environmental conditions for safe
operation
There should be enough space to make sure that the ventilation grills on the front and back
are not covered and sufficient ventilation is provided. The accessibility of the power switch
must not be hindered. There should be a distance of at least 25 cm (10 inch) to the wall or the
next device. Two thermal cyclers should not be placed back-to-back or back to front.
The instrument is designed for indoor use only, temperature range of 10 to 35 °C and
humidity of 35 to 70% are recommended
If the instrument has just been unpacked or has been stored in a cold environment, it should
be allowed to come to room temperature for 2 – 3 hours in the laboratory before switching
on. This will prevent calibration failure because of internal condensation
The instrument must be connected to the power supply with the power cord supplied.
It is recommended that users should thoroughly read this manual prior to use
Contact your supplier if you experience any difficulties with this instrument
To Next Page
Loading...
