TEBS E
11
Workshop notes
191
Any modifications to the control - and braking pressures may only deviate up to a
maximum of 0.2 bar from those given in the brake calculation (parameter settings
of the manufacturer). Otherwise a new brake calculation must be generated. Con-
tact your vehicle manufacturer in this case.
Setting a predominance
In the TEBS E Diagnostic Software there is a field Predominance. 0 bar is defined
here as default. You can set a value up to ±0.2 bar.
A positive value allows the trailer vehicle to brake earlier. A negative value causes
the trailer vehicle to brake later.
Documentation
Document the changes by a print-out of the system label sheet, see chapter 9.5
‘Documentation’, page 171.
To Next Page
Loading...
