DPU 130Le 3 Safety
Operator's manual
25
Disconnecting the battery
For machines with electric starter, you must disconnect the battery before
working on the electronic parts.
Using only a Wacker Neuson battery
Use only Wacker Neuson batteries to replace defective batteries, see chapter
Technical Data.
Only the Wacker Neuson battery is vibration resistant and thus suitable for the
high vibratory stresses.
Working on the battery
Always take the following safety measures when working with the battery:
No fire, sparks, or smoking while working with batteries.
Batteries contain corrosive acid. Use acid-proof protective gloves and
protective goggles when working with batteries.
Avoid short circuits due to improper connection or bypassing with tools.
Disconnect the negative terminal first when disconnecting the battery.
Connect the positive terminal first when connecting the battery.
Re-fasten terminal covers after connecting the battery.
Assembling safety devices
If it was necessary to dismantle safety devices, they must be reassembled and
checked immediately after completing maintenance work.
Always tighten loosened screw connections, complying with prescribed starting
torque.
Handling operating fluids safely
Observe the following points when handling operating fluids, e.g. fuels, oils,
greases, coolants etc.:
Always wear personal safety clothing.
Avoid skin and eye contact with operating fluids.
Do not inhale or swallow operating fluids.
In particular, avoid contact with hot operating fluids. Burn and scalding
hazard.
Dispose of replaced or spilled operating fluids according to the applicable
regulations for environmental protection.
If operating fluids escape from the machine, cease operation of the machine
and have it repaired immediately by your Wacker Neuson representative.
To Next Page
Loading...
Need help?
General
