EasyManua.ls Logo

Wacker Neuson DPU130Le

Wacker Neuson DPU130Le
108 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9 Maintenance
77
100_0202_mt_0004.fm
Topping up with fuel
1. Remove any dirt around the fuel cap.
2. Unscrew and remove the fuel tank lid.
3. If necessary, remove and clean the dirty fuel filter.
Replace fuel filter before refilling.
4. Replenish the fuel to the maximum mark (see chapter Technical data for the
fuel type).
5. Position the fuel cap and tighten it.
6. Close rear protective hood.
Note: Dispose of dirt on the fuel filter according to the applicable regulations for
environmental protection.
Item Designation Item Designation
1 Maximum marking 3 Fuel filter
2 Fuel cap

Table of Contents

Related product manuals