9 Maintenance
100_0202_mt_0004.fm
84
Checking coolant level in radiator
1. Remove any dirt around the radiator cap.
2. Slowly unscrew and remove radiator cap.
3. Check if the coolant reaches the lower edge of the filler neck.
Topping up coolant in radiator
Note: If the machine is losing coolant, check the cooling system for leaks and
have the machine repaired by the Wacker Neuson representative.
1. If necessary, add coolant up to the upper edge of the filler neck (for coolant
specification, see Chapter Technical data).
2. Replace the radiator cap and tighten it.
WARNING
The cooling system is under pressure.
Hot coolant can spurt out and cause scalding injuries.
X Only open the radiator cap once the engine has cooled down.
To Next Page
Loading...
Need help?
General
