EasyManuals Logo

Wacker Neuson DPU130Le User Manual

Wacker Neuson DPU130Le
108 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #88 background imageLoading...
Page #88 background image
9 Maintenance
100_0202_mt_0004.fm
88
Topping up with hydraulic oil
Note: If the machine is losing hydraulic oil, check the hydraulic lines for leaks
and have the machine repaired by the Wacker Neuson representative.
1. Remove any dirt around the hydraulic oil tank.
2. Unscrew and remove hydraulic oil tank cap.
3. Add hydraulic oil until the hydraulic oil reaches the middle of the oil level glass
(for oil specifications see Chapter Technical Data).
4. Replace the hydraulic oil tank cap and screw it on tightly (torque 10 Nm).
Make sure that the cap seal is correctly positioned.
WARNING
Hot hydraulic oil can cause scalding injuries.
X Do not open the screw plug on the hydraulic oil tank while the hydraulic oil is
hot.
X Let machine cool off.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Wacker Neuson DPU130Le and is the answer not in the manual?

Wacker Neuson DPU130Le Specifications

General IconGeneral
BrandWacker Neuson
ModelDPU130Le
CategoryPower Tool
LanguageEnglish

Related product manuals