BA E14 track en* 1.3 * E14t_13_510.fm 5-39
Operation 5
Setting down an attachment
1. Screw in the attachment and position it at 5–10 cm (2–4 in) above the
ground.
2. Shut off the engine and store the ignition switch key safely.
3. ET65: Turn the socket wrench D counter-clockwise until the pins E are
completely retracted.
➥ The quick coupler system is unlocked.
EZ80/ET90: Screw the socket wrench F completely over dead center
(ca. 120°), until the pins E are fully retracted. Because of the spring
support, hold tightly to the socket wrench when unlocking.
➥ The quick coupler system is unlocked.
4. Remove the socket wrench.
5. Start the engine.
6. Lower the attachment to level and firm ground ensuring stability.
7. Retract the bucket cylinder and quick coupler system A from the
attachment bolt B.
To Next Page
Loading...
