Wacker Neuson ET65 - Page 181

BA E14 track en* 1.3 * E14t_13_510.fm 5-53
Operation 5
AUX V (option)
Changeover is performed on one side of the boom.
The ball-type cock is located at the end of the boom.
Position the boom straight ahead at the center of the vehicle (see figure).
Lower the boom and the stabilizer blade to the ground.
Selecting:
Set ball-type cock A to the required position with lever B on one side of
the stick.
Information
Lever B must always be removed before operation.
Fig. 226
Fig. 227
B
A
Gear wheel position Operating
Bucket operation
Grab operation
Fig. 228
A
B