10 Maintenance
26 100_0202_mt_0016.fm
10.1 Maintenance table
10.2 Maintenance jobs
Carry out preparations
1. Place the machine on a level surface.
2. Decommissioning the machine.
3. Allow engine to cool down.
Maintenance jobs Daily h Weekly Monthly
Clean the machine
Visual inspection for completeness
Visual inspection for damage
Check the engine oil level*
Check the intake area of the combustion air*
Check the to ensure the screwed connections are firmly
seated
Clean the fuel sieve cup
Replace the engine oil* 20 h
1
/ 100 h
Check the valve clearance** 300 h
Check the spark plugs ** 100 h
Check the rubber buffer** 100 h
Replace exciter oil** 200 h
Replace the fuel filter* 500 h
Clean the air cleaner cartridge*
Air filter insert with cyclone separator, clean. 150 h / 600 h
Check water trap*
Check the exciter oil level 100 h
Retention/replace the V-belt 50 h / 200 h
1
Perform first oil change after 20 hours.
*
Note the engine operator's manual.
**
Have this work performed by the service department of your Wacker Neuson contact partner.
CAUTION
Health risk from fuel, lubricants and coolants.
Do not inhale fuel, lubricants, coolants or vapors.
Avoid contact of skin or eyes with fuel, lubricants and coolants.
WARNING
Risk of fire and explosion from fuel and fuel vapors.
Do not smoke.
Do not refuel near open flames.
Switch off engine and allow to cool before refueling. Only refuel in a well-ventilated
vicinity.
To Next Page
Loading...
Need help?
General
