sequence.
On the DISPLAY TOGGLE tab all
monitors are selected in the toggle
sequence by default. Uncheck any
monitor you want removed from the
toggle sequence.
• The base mapping is the tablet
and display mapping that is
defined in the M
APPING tab.
By default, this would include all
monitors unless you have
defined a specific monitor as
your primary monitor in the
M
APPING tab.
• As you toggle to the next
monitor, each tool’s active tablet
area is mapped to that monitor
(in P
EN mode).
• Toggling one more time after the
last checked monitor returns the
system to the base mapping.
Note that any of the following actions will return the toggle sequence to the base mapping:
• Launching a graphics application that supports pressure sensitivity.
• Logging out of or rebooting the system.
• Switching users (Fast User Switching).
• Placing the system in sleep mode.
• Changing the M
APPING or DISPLAY TOGGLE tab settings.
• Changing the resolution or number of displays on your system.
• Using the M
ODE TOGGLE... function.
• Selecting P
EN MODE or MOUSE MODE from the Radial Menu.
Tip: To toggle between monitors without including the ‘full display’ option, disable the first display on the D
ISPLAY
T
OGGLE tab. Then go to the MAPPING tab and set the current SCREEN AREA to the first display.
Important: When using application-specific settings with
D
ISPLAY TOGGLE, make sure that each customized
application in the A
PPLICATION list (including ALL OTHER) has
a tool button assigned to D
ISPLAY TOGGLE. The easiest way
to do this is to assign DISPLAY TOGGLE to an ExpressKey
prior to creating any application-specific settings.
To Next Page
Loading...
Need help?
General
