WACOM Intuos4 Large User Manual

77
77
Index
Contents
IndexContents
WORKING WITH AUTOCAD
AutoCAD can support the Intuos4 tablet as a Windows system pointing device or as a Wintab compatible
digitizer. By default, AutoCAD is configured to use Intuos4 as a system pointing device.
Follow the below procedures if you will be using Intuos4 with tablet menus or to digitize drawings to proper
scale.
Note: To configure the mouse or lens cursor for left-handed use in AutoCAD or similar applications, open the
Wacom Tablet control panel, click on O
PTIONS... and select LEFT in the MOUSE HANDEDNESS group.
Configuring AutoCAD for a Wintab compatible digitizer
Configuring tablet menus and screen pointing areas in AutoCAD
Calibrating Intuos4 for AutoCAD
CONFIGURING AUTOCAD FOR A WINTAB COMPATIBLE DIGITIZER
1. Start AutoCAD. Open the TOOLS menu and select OPTIONS.
2. From the O
PTIONS window, select the SYSTEM tab.
3. Under C
URRENT POINTING DEVICE, select the WINTAB COMPATIBLE DIGITIZER option.
4. Decide from which device AutoCAD will accept input. Choose an option from the A
CCEPT INPUT FROM
section:
• D
IGITIZER ONLY. The AutoCAD drawing editor only accepts input from Intuos4.
• D
IGITIZER AND MOUSE. The AutoCAD drawing editor accepts input from both Intuos4 and your
mouse.
5. Click OK to close the O
PTIONS window.

WACOM Intuos4 Large Specifications

General

Brand	WACOM
Model	Intuos4 Large
Category	Tablet
Language	English