WAGNER EPG-Sprint X Original Service Manual

9
EPG-SPRINT / EPG-SPRINT X
SERVICE MANUAL
VERSION 09/2017 ORDER NUMBER DOC2309350
2.5 REASONABLY FORESEEABLE MISUSE
– Coating work pieces which are not grounded
– Use of defective components and accessories
– Use with not permissible powder coating guns
2.4 SAFETY PARAMETERS
WAGNER accepts no liability for any damage arising from incorrect use.
Electrostatic spray equipment may only be operated in an intact condition, damaged
devices must be decommissioned immediately and repaired.
Use the device only to work with the products recommended by WAGNER.
Only operate the device as a whole.
Do not deactivate safety  xtures.
Spare parts and accessories may have safety-relevant properties.
Use only WAGNER original spare parts and accessories.
The use of the control unit is only permissible under the following conditions:
the operating sta have previously been trained on the basis of this operating manual,
the safety regulations listed in this service manual are observed,
the operating, maintenance and repair information in this service manual is observed,
and the statutory requirements and accident prevention regulations standards in the
country of use are observed.

WAGNER EPG-Sprint X Specifications

General

Brand	WAGNER
Model	EPG-Sprint X
Category	Control Unit
Language	English