WAGNER EPG-SPRINT XE

35
EPG-SPRINT XE
OPERATING MANUAL
VERSION 09/2017 ORDER NUMBER DOC2354913
Damage to the device!
The control unit must be connected and grounded according to the directions in
chapter 5.
After switching on the unit, wait for the start up phase to be completed. A function
test is performed in the start up phase. At the end of the tests, the connected gun
type is detected and displayed.
Do not actuate the trigger on a manual spray gun in the start-up phase, if the gun
is used as a single device in a manual coating system. If the trigger is actuated, the
control unit will detect it as an automatic gun and wait for the actuation signal from
remote control. The unit cannot be switched on.
NOTICE