Operating manual Piston pump IceBreaker 40-200 ccm (Finishing)
6 Assembly and Commissioning
Order number 2333538 | Edition 03/2021 41
6 ASSEMBLY AND COMMISSIONING
6.1 TRAINING OF ASSEMBLY/COMMISSIONING PERSONNEL
– The assembly and commissioning personnel must have the technical skills to safely
commission the device.
– When assembling, commissioning and carrying out all work, read and follow the
operating manuals and safety regulations for the additionally required system
components.
A skilled person must check to ensure that the device is in a reliable state after it is
assembled and commissioned.
6.2 STORAGE CONDITIONS
Until the point of assembly, the device must be stored in a dry location, free from vibrations
and with a minimum of dust. The device must be stored in closed rooms.
The air temperature at the storage location must be between -20°C and +60°C; -4°F and
+140°F.
The relative air humidity at the storage location must be between 10 and 95% (without
condensation).
6.3 INSTALLATION CONDITIONS
The air temperature at the installation site must be in a range between 5°C and 50°C; 41°F
and 122°F.
The relative air humidity at the installation site must be between 10 and 95% (without
condensation).
6.4 TRANSPORTATION
Only the pump, without trolleys, may be lifted by the lifting eye nut or lifting eye bolt (see
accessories) and transported short distances.
Wildcat, Puma and Leopard: The pump can be moved on a trolley or manually without lifting
equipment or a crane.
To Next Page
Loading...
