PEM-C2
Powder Spraygun PEM-C2 Part No. 0351 021
A
B
D
H
C
E
G
F
A Electrode
B Deflector cone
C Outer nut
D Spraygun body
E Trigger
F Atomizing air supply
G Powder supply
H Power supply
The powder spraygun PEM-C2 is used for industrial powder coating.
This spraygun can be operated with the following control units:
• EPG 2007 with powder injector PJ 2020 PRS
• EPG Digiflow with powder injector PJ-D1
The high voltage in the spraygun is activated by pressing the trigger. At the same time, the
powder and compressed air supplies to the gun are turned on.
Caution
The user must ensure, that the spraygun is only connected to
Wagner equipment!
High ambient temperatures must be avoided; in particular, the hoses must not
be routed through factory areas exposed to direct sunlight!
To provide a safeguard against unintentional use of the spraygun, the control
unit must be turned off!
Powders containing metal pigments may only be processed in compliance with
the powder manufacturer’s instructions.
02/01 2 0351801
To Next Page
Loading...
