WAGNER PEM-C2 - 1 Introduction

PEM-C2
1. Introduction
This technical manual contains information and hints for the service, repair and maintenance
of the equipment. The observation of this manual is element of the warranty agreements.
Wagner powder systems are designed to meet the most stringent safety requirements. They
can be operated in compliance with generally applicable safety codes and applicable national
safety regulations.
Please pay particular attention to the parts marked by the following symbols. Follow the
instructions exactly, in the interests of both your own safety and the correct functioning of the
unit.
Warning
This warning draws attention to the fact that if the operating instructions,
working instructions, prescribed working sequences etc. are not followed
exactly, this can lead to injury or even fatal accidents.
Caution
This warning indicates that if the operating instructions, working instructions,
prescribed working sequences etc. are not followed exactly, this can lead to
damage to the unit.
Hint
This symbol draws your attention to useful additional information and tips.
Wagner hereby declares that the unit described in these operating instructions has
been designed and manufactured according to the provisions of EU Directive
98/37/EC.
The following harmonized standards have been applied:
EN 50014 EN 50053
EN 50050 EN 1953
The following German standards or guidelines have been applied:
ZH 1/443 VDE 0165
VDMA 24371 part 1
The certificate of conformity with the order No. 0351 932 is enclosed with this product. This
can be reordered from your WAGNER representative giving the product and serial number.
02/01 5 0351801