WAGNER PER-X1 - Mounting the Double Adapter; Removing the Nozzle and Electrode Holder

Operating manual Robot powder spray gun PER-X1
8 Cleaning and Maintenance
42 Order number 2444998 | Edition 10/2022
P_01690
8.
7.
9.
6.
5. Before inserting the electrode holder, the spring contact of the gun body and contact
surface of the electrode holder should be checked.
The spring contact must be clean and move easily, the gun body must also be clean
and free of powder deposits.
6. Insert electrode holder into gun housing.
7. Slide union nut onto gun housing.
8. Screw union nut onto gun housing (hand-tight).
9. Slide deflector cone over deflector cone sleeve.
8.8 MOUNTING THE DOUBLE ADAPTER
8.8.1 Removing the Nozzle and Electrode Holder
The standard automatic gun is delivered either with a flat jet nozzle or a round jet nozzle.
The nozzle can be changed easily, as described below.
Note:
The double adapter is needed to perform the change, as shown in chapter Double Adapter
[854].
Either a flat jet nozzle or a round jet nozzle can be fitted into the double adapter.