52
TwinControl .
OPERATING MANUAL
EDITION 04/2010 PART NO. DOC393831
WARNING
High-pressure spray jet!
Danger to life from injecting paint or solvent
Never reach into the spray jet.
Never point the spray gun at peole.
Consult a doctor immediately in the event of skin injuries caused
by paint or solvent.Inform the doctor about the paint or solvent
used.
Never seal defective high-pressure parts, instead relieve the
pressure from them and replace.
Wear the appropriate protective clothing, gloves, eyewear, and
respirator.
SIHI_0059_GB
6.8 GENERAL
➞ The fl ushing agent pressure for A and B and the material pressure for the A and B
components must always be present on the device during operation.
➞ Make sure that the nozzle is inserted in the gun when feeding the material hose. The
fl ushing process must always be performed without the nozzle in the gun.
➞ It is important that the level in the A and B material containers and in the fl ushing
material container is checked visually, in order to prevent unintended interruptions in
the spray process.
To Next Page
Loading...
