60
TwinControl .
OPERATING MANUAL
EDITION 04/2010 PART NO. DOC393831
7.1 CLEANING THE SYSTEM
7 MAINTENANCE
SIHI_0004_GB
WARNING
Incorrect maintenance/repair!
Risk of injury and damage to the equipment
Repairs and part replacement may only be carried out by spe-
cially trained staff or a WAGNER service center.
Before all work on the unit and in the event of work interrup-
tions:
- Switch off the energy/compressed air supply.
- Relieve the pressure from the spray gun and unit.
- Secure the spray gun against actuation.
Observe the operating and service instructions when carrying
out all work.
7.2 CLEANING THE FILTERS
In accordance with the guideline for liquid spray devices (ZH 1/406 and BGR 500 Part
2, chap. 2.36):
– The occupational safety state of the liquid spray devices is to be inspected as required,
however at least every 12 months by an expert (e.g.Wagner service technician).
– In case of non-operative units the test can be postponed until the next start-up.
!CLEANEDUNITMAKESANEASYLOCALIZATIONOFANYLEAKAGEANDQUICKREPAIR
2EFERTOTHECORRESPONDINGMANUALTOCLEANTHElLTERSONTHESUPPLYINGPUMPSANDIN
THESPRAYGUN
To Next Page
Loading...
