07610-003-67-17-K
14
In order to maintain the dishmachine at its optimum performance level, lime and
corrosion deposits must be removed. The frequency for deliming will be based on
water conditions. A deliming solution is available from your chemical supplier. Read
and follow all instructions on the label.
To delime the dishmachine:
1. Turn the machine on by pressing the ON/OFF button.
2. Press and hold the FILL button until water overflows into the wash strainer.
3. Add deliming solution per supplier’s instructions.
4. Close the door.
5. Flip the NORMAL/DELIME switch to DELIME.
6. Run machine the period of time recommended by chemical supplier.
7. Wait ve minutes, then inspect the inside of the machine. If the machine is not
delimed, run again.
8. Flip the NORMAL/DELIME switch to NORMAL.
9. Run two cycles to remove residual deliming solution.
DELIMING
NOTE: If this machine is
equipped with an
HTS-11 scale prevention
and corrosion control
device and lime is
becoming a frequent
problem, the cartridge
needs to be replaced.
To order a replacement
cartridge, call the
manufacturer.
INSTRUCTIONS
OPERATION
To Next Page
Loading...