Chapter 5
PREAMBLE/POSTAMBLE , TERMINATOR AND LABEL TYPE
*Default
The ‘Preamble/Postamble’ configuration is used to add a prefix or suffix set of characters to the barcode value. Up to 8 characters
may be added for each option separately. Preamble and postamble characters can function concurrently, but need to be configured
separately.
To add preamble or postamble characters, follow the steps below:
1) Scan the ‘Clear Pre/Postamble’ barcode on this page.
2) Scan the ‘Preamble’ or ‘Postamble’ barcode.
3) Use Appendix B on pages 27-30 to locate the characters you want to add as preamble or postamble characters. Make sure that
you scan the barcode associated with each letter before preceding to the next character. For example, to add the letter “A,” scan
the barcode corresponding to the letter “A”. The letter “A” will always appear in your data as prefix or suffix to the
barcode value.
4) Scan the corresponding ‘Pre/Postamble’ barcode on this page to exit this setting.
Clear Pre/Postamble
Preamble
Postamble
Terminator
CR *
None
LF
CR + LF
Tab
Space
ESC
The ‘Terminator’ option is used to specify the end-of-text message and is primarily used to denote the end of the barcode value.
10
Preamble/Postamble
To Next Page
Loading...
