Watson-Marlow 720DuN User Manual 30
Setup
Setup allows the user to set the pump’s operating parameters under 23 headings:
Trim, Analogue, Display, Pump I/D, Baud, Stop bits, Xon/Xoff, Flow units, Run time,
Outputs, Remote stop, Auto-restart, Set max speed, Set min speed, Scrolling,
Date/time, Backlight, ROM, Language, Defaults, Beep, Security code and Exit.
Pin out details
Pin out information is not relevant to 720DuN IP66/NEMA 4X pumps. Selecting Pin
out details causes the pump to display a warning screen and redisplay the main
menu.
MemoDose
The MemoDose facility is used to remember the number of revolutions needed to
dispense the most recently dispensed volume of fluid, and cause the pump to dis-
pense that volume repeatedly.
Exit
If Exit is selected, the pump returns to its last manual state with the pump stopped.
To Next Page
Loading...
Need help?
General
