Watson-Marlow 720DuN User Manual 43
18.4 Pump I/D
The 720DuN pump can be individually controlled under RS485 as one of up to 32
pumps. First the pump must be given its identity number.
In the first screen of the Setup menu select Pump I/D using the UP and
DOWN keys. Press ENTER to confirm your choice.
The pump displays a screen allowing you to change the pump’s identity num-
ber. Use the numeric keys to enter a new number in the display and press
ENTER to confirm your decision. An example is shown here.
The pump displays the first screen of the Setup menu.
18.5 Baud
The pump can be set to communicate with control devices at a choice of baud rates.
In the first screen of the Setup menu select Baud using the UP and DOWN
keys. Press ENTER to confirm your choice.
The pump displays a screen allowing you to change the pump’s baud rate. Use
the UP and DOWN keys to select 1200, 2400, 4800, 9600 or 19k2) and
press ENTER to confirm your decision.
The pump displays the first screen of the Setup menu.
To Next Page
Loading...
Need help?
General
