not operate the brake lever when the wheel is detached from the frame
or the fork.
To align the mechanical disc brake caliper (19) (9):
• Loosen the fixing screws of the brake caliper bracket. Brake
with the corresponding brake lever (the brake caliper is
positioned correctly) and hold the brake lever in this position
while tightening the caliper bracket fixing screws.
• Check that the internal pad (inside the wheel) is at 0.2 - 0.4 mm
from the disc. If this is not enough, tighten the pad positioning
screw until a gap of 0.2 - 0.4 mm between the pad and the disc
is obtained.
• To adjust the external pad (outside the wheel), simply modify
the tension of the brake cable in order to obtain a gap of 0.2 -
0.4 mm, at the caliper or at the brake lever.
Never spray oil or any lubricant on the disc or pads (when servicing
the chain or the derailleur, for example). If this happens, remove the
grease from the pads and disc, or change them. Check the alignment
of the pads by turning the wheel.
• A nut and lock nut system on the brake lever allows you to
adjust the cable tension and therefore the braking force which
will vary over time depending on the wear of the brake pads.
• The brake pads are standard, they should be replaced when
they no longer have a friction component. The reference of the
brake pads fitted to your bike is as follows: model: MD-280 -
reference: E10.11
To Next Page
Loading...
