Thermo Top Evo 10 Packing, Storage and Shipping
1001
10 Packing, Storage and Shipping
10.1 General
If the heater or its components are sent to Webasto AG for
testing or repair, it must be cleaned and packed in such a
way that it is protected against mechanical damage, soiling
and environmental influences during handling, transport
and storage.
The temperatures during transport and storage may not
drop below -40 and may not exceed 60 °C.
10.2 Storage
Heater position:
The heater can be stored in any position. There are no re-
strictions here.
Heaters must always be stored in the delivery packaging or
in similarly suitable packaging in closed rooms!
After being removed from the delivery packaging, the heat-
ers should only make contact on the aluminium parts (for
position, see Fig. 1001). The type label and the surface of
the heater must be protected against damage with a suita-
ble surface (e.g. cardboard).
During storage the heater should be covered and must be
protected from dust, dirt and moisture.
The heater may not come into contact with chemicals or
their vapours, e.g. fuel, battery fluids or brake fluids.
No dirt, water or chemicals may enter into the openings of
the heater during storage, see above.
The fuel pipe must be protected from side impact loads
which lead to pipe deformation.
10.3 Transport
The heater can be transported in any position and must al-
ways be packed in suitable packing.
The electrical contacts and the fuel pipe must be protected
against mechanical damage.
NOTE
If an entire heater is returned, then it must be completely
drained of operating fluids. It must be ensured that no fuel
or coolant residues can escape during packing and/or ship-
ping.The coolant connection piece and the fuel connection
must be sealed off with blind plugs.
Fig. 1001 Preferred position for Thermo Top Evo heater for storage and transport
Visit www.butlertechnik.com for more technical information and downloads.
To Next Page
Loading...
