32. Insertthe two LockingPins (53) into the Butterfly
Frame (9). Attach the tether on the Pins to the
Butterfly Frame with the M4 x 10mm Screw (68).
32
9
53
33. Make sure that all parts have been properlytightened.The use of all remainingparts will be explained in
ADJUSTMENTS, below.
Before usingtheweight system,pulleach cable a few timesto make surethat the cablesmove smoothly
over the pulleys.Ifone of the cables does not move smoothly,find and correctthe problem.IMPORTANT: If
the cables are not properly routed, they may be damaged when heavy weight Is used. See the CABLE
DIAGRAM on page 17 of this manual for proper cable routing. If there Is any alack In the cables, you
wM need to remove It by Ughtenlng the cables; see TIGHTENING THE CABLES on page 15.
ADJUSTMENTS
This sectionexplains how to adjustthe weight system.See the EXERCISE GUIDELINES on page 18 for impor-
tant informationabout how to get the mostbenefitfrom yourexercise program.Also, refer to the accompanying
exercise guide to see the correctform for each exercise.
Make sure all partsare properly tightenedeach timethe weightsystem isused. Replaceanywornpartsimmediate-
ly.The weightsystemcan be cleanedwitha damp clothand a mild,non-abrasivedetergent.Do not use solvents.
A'n'ACHING THE ACCESSORIES TO A PULLEY
STATION
Attach the Lat Bar (42) to the High Cable (45) with a
Cable Clip (52). For some exercises,the Chain (not
shown) should be attached between the Lat Bar and
the High Cable with two Cable Clips. Adjust the
length of the Chain between the Lat Bar and the
Short Cable so the Lat Bar Is In the correct start-
ing position for the exercise to be performed.
The Handle (not shown) can be attached in the same
manner. The accessoriescan be attached to the Low
Cable (not shown) in the same manner.
14
To Next Page
Loading...
