Warning of hot surface
The curing process makes MultiCards
and MetalliCards very hot. Let
MultiCards/MetalliCards cool off before
removing them from the output rail.
• The openings in the enclosure of the printer
must not be blocked or covered over.
• Do not insert any unintended objects through
these openings.
• Make sure that no liquid gets into the printer.
• Do not switch off the printer! The printer
automatically goes into standby mode. The
operating parameters are only retained while the
printer is turned on. These parameters ensure,
for example, that the printhead is cleaned
optimally.
• If the printer is turned off or is not used, this can
lead to blockage of the ink nozzles after some
time.
• Print some MultiCards/MetalliCards every week.
This is the only way to preserve print quality.
• Only remove ink cartridges when they are empty
or have expired.
Removing an ink cartridge can cause leaks in
the connection between the ink cartridge and the
ink line. This can lead to a faulty ink feed
system.
• Do not use ink that has expired.
When the ink expiration date is approaching, a
message is displayed on the touch panel.
Replace the specified ink cartridge (see section
“Replacing ink cartridges”).
• Only use products that have been produced or
approved by Weidmüller (M-Print® PRO
software, MultiCards/ MetalliCards and ink
cartridges). Otherwise no liability can be
assumed for the quality and durability of printing.
Important information
Printer faults and damage caused by the
use of unapproved and unsuitable
accessories and consumables are
excluded from the warranty.
To Next Page
Loading...