Weidmüller PrintJet ADVANCED - Inserting Multicards;Metallicards

Operation
1449820000/1.4/04.17 79
5.1.2 Inserting
MultiCards/MetalliCards
Direction of insertion for MultiCards
Figure 86 Direction of insertion for MultiCards
MultiCards can be inserted directly without any prior
handling.
The end with the solid margin must be fed into the
printer.
Inserting a MetalliCard in the inlay
1 Before inserting the MetalliCard in the inlay,
remove the protective plastic film that is attached
to the MetalliCard.
2 Clean the MetalliCard with a moist cloth (Primer
CC-M – 1341200000).
3 Hold the MetalliCard at the side when inserting it
in the inlay.
Do not touch the area to be printed as that reduces
the print quality.
Figure 87 Opening the inlay
1 Open the inlay’s lock (A) and raise the bar.
Figure 88 Inserting a MetalliCard in the inlay
2 Insert the MetalliCard (C) in the inlay (D).
3 Lower the bar (B) and close the lock.