Operation
1449820000/1.4/04.17 89
5.2.4 Setting material-dependent slip
The material-dependent slip correction must take place for every MultiCard version, as it must be
set material dependently.
1 From the menu bar choose Tools → Printer Settings → Set Material-Dependent Slip...
2 Insert, for example, a DEK 5/5 MC-10 NEUTRAL WS MultiCard in the printer (also see section “5.1.2
Inserting MultiCards/MetalliCards”).
Figure 103 Setting material-dependent slip
3 Print a rectangle of the specified size (228 x 46 mm) by pressing the [Print Rectangle] button.
4 Remove the printed MultiCard from the printer.
5 Measure the size of the printed rectangle.
To Next Page
Loading...