Operation
1449820000/1.4/04.17 91
5.2.5 Adjusting MultiCards
MultiCards may not be their normal size, for example as a result of the ambient temperature. It is generally
the width that is affected by such a change. You can adjust MultiCards to compensate for these physical
changes. The adjustment must be set for every MultiCard type.
1 From the menu bar choose File → Adjust Marker Type...
Figure 105 Adjusting the marker type
2 Measure the width (X) from the beginning of the first project marker to the beginning of the last project
marker (see figure above).
3 To determine the height (Y), measure from the lower edge of the bottom marker to the upper edge of the
top marker (see figure above).
4 Enter the actual measured values in the ‛Width (X)’ and ‛Height (Y)’ fields.
To Next Page
Loading...