weinor Opal Design II LED User Manual

Instructions for Assembly
Item number 116523-0000
We reserve the right to make technical
changes
Version 4 01.04.2014 Page 44/49
Opal Design II / Opal Design II LED
12 Troubleshooting
Error Cause Remedy
Drive not running
 No power
 Drive incorrectly connected
 Drive is too hot
 Drive is defective
 Pre-set control not
functioning

Authorised person only
 Re-connect drive (authorised
personnel only)
 Wait 10 to 15 min
 Replace drive (authorised
personnel only)
 Authorised person only
Unit does not retract
completely
Drive not set correctly
Foreign body blockage
Correct the drive settings (fitter)
Remove foreign bodies
Unit not straight Unit not correctly aligned Align drive (fitter)
Not enough fabric tension End stop position exceeded Correct the drive settings (fitter)
Drop profile not horizontal
when awning is open
Unit not correctly aligned Adjust inclination of arms
Unit does not close across
its entire width
Fabric seam not straight
Fabric has stretched to differing
lengths
Line fabric
Creasing and wrinkling Restricted unit None
A system part does not
close in 2-field systems
System parts are wrongly
coupled
Different fabric lengths
Check the system coupling
Use fabrics of the same length
Crescent-shaped cap
does not lock correctly
Miscellaneous Adjust the crescent-shaped cap
13 Handover
All directions for use and maintenance documents must be handed over to the user at the time
of instruction. Detailed instruction on the safe and proper operation of the awning must be given.
If this is not adhered to and the awning is operated incorrectly, damage to the awning or
accidents could result. The instructions must be kept by the customer and passed on to the new
owner if ownership of the awning passes to a third party.
After noting the on-site structural conditions and completing assembly, the installation firm is to
inform the user whether the wind resistance class given by the manufacturer was achieved after
installing the awning. If not, the installation firm must record the wind resistance class actually
achieved. Automatic controls must be set to this level. The customer must confirm to the fitter in
writing that the awning is the right model and has been installed correctly, indicating the
assembly time, and that final acceptance of the awning has taken place during which the safety
issues were discussed.
www.samsondoors.co.uk
0800 328 6250
www.samsondoors.co.uk
www.samsondoors.co.uk
0800 328 6250
www.samsondoors.co.uk

weinor Opal Design II LED Specifications

General

Brand	weinor
Model	Opal Design II LED
Category	Accessories
Language	English