WEISS TM15 - Indexer Configuration Via File

Manual R06-201686 / 172
ROTARY INDEXING TABLE CONTROLLER EF2...B
OPERATION / DESCRIPTION OF WEISS SOFTWARE | 8.3 Machine configuration
8.3.4.2 Indexer configuration via file
"Indexer configuration via file" is not possible during initial startup because no configuration file
has been stored yet.
1. Start "Indexer configuration via file".
2. Confirm the message with OK.
3. Choose action.
Selection:
• (a) "Load file" - load configuration file from computer
➱ Selection of a saved configuration file
➱ Loading a selected configuration file
• (b) "Load backup file" - load from the controller internal backup file
➱ Reloads the configuration from the controller internal backup file that was saved last.
• (c) Abort configuration
➱ Aborting the configuration => restart the controller
1.
2.
3. ba
c